Use and Care Manual

www.coolazone.com
7
C-100 Controls
USING YOUR C-100
1 - Power Button: turns the unit
ON or OFF.
2 - Speed Button: this controls
the airfl ow. On fi rst operation,
the C-100 will be at SPEED 2
(there are three Speeds, 1
being the lowest and 3 being
SHOW
AIRFLOW
SPEED
BUTTON
POWER
(ON/OFF)
COOL
INDICATOR
COOL
ON/OFF
SHOW
VENITILATION
ANION
INDICATOR
123
4
5
6
the highest). Pressing again will take you up to SPEED 3, then
pressing it again will bring you down to SPEED 1. The rate of
speed will be refl ected on the Airfl ow Indicator. If using the
remote control, simply hit the up or down arrows to control the
airfl ow speed (see Page 5).
3 - The Cool Button: switches the Cool-A-Zone C-100 from
COOL to VENTILATION modes. One press will switch between
the two functions. The COOL mode will activate the pump
and water will be used to evaporatively cool, “whereas”
the VENTILATION mode will simply circulate the air and
deactivates the pump. If using the remote control, there are
one button each for the COOL and VENTILATION modes (see
Page 5).
4 - The Cool Indicator: When lit, this indicates that the Cool-
A-Zone C-100 is in COOL mode. When unlit, this inidcates the
Cool-A-Zone C-100 is in VENTILATION mode.
5 - The Airfl ow Indicator: The lowest bar indicates SPEED 1, the
middle bar indicates SPEED 2, and the highest bar indicates
SPEED 3.
6 - The Anion Indicator: When lit, the Anion function is ON,
when unlit, the Anion function is OFF.