Use and Care Manual

www.coolazone.com

INSTALLATION AND INITIAL SET-UP:

If the fan must be placed close to a wall or other obstacle, try to keep a

distance of 2 to 3 feet between the wall or obstacle and the face of the

cooling pads.

When placing the fan, take the following into consideration:

a. Uninterrupted fresh air should be made available to the cooling

pad side of the unit for best results.

b. Avoid blocking the air output (front) side of the fan. Cool air

released from the unit should be able to freely circulate.

c. In order to prevent air from being re-circulated, ensure that the

area to be cooled is properly ventilated.

d. If your C-100 did not come with the truckles (the wheel assembly

legs) attached, please see the below instructions on how to do so.

1) Take two sets the Truckles (above left, shown unattached).

2) Use the enclosed ST5×25 bolts to stable the assembled frame to the

bottom of the water tank through the attaching points as shown on

the left which will line up with corresponding points on the unit.

3) When completed, the ﬁ nished truckle-body assembly area should

look as shown above on the right.

Installation & Set-Up

Truckle Attaching Points Finished Assembly

Truckle Unattached Truckle Attached