User Manual

USE AND CARE
7
LED Operation on 4-Qt Drop-In
Souper Liner
The 4-qt drop-in Soupers will have three red LEDs
on the top edge of the liner:
• When the unit is plugged in, the LEDs will remain
on for 10 seconds.
• When the tureen is placed in the liner, the LEDs
will flash for 5 seconds.
• If the tureen is removed or no longer detected, the
LEDs will turn on until the tureen is reinserted
and detected.
• If there is an error, the LEDs will flash a certain
number of times corresponding to the error code,
and repeat until the error condition is cleared. For
example, an E-3 error will cause the LEDs to flash
3 times repeatedly.
Maintenance
Follow the steps below when cleaning your SinAqua™
Souper™. Failure to adhere to these procedures may
damage components, resulting in a non-warranty
service call.
Step 1: Turn the Unit O and Allow it to Cool
• Turn off the unit by touching the power button.
• If there is food in the tureen, remove and store it
as required.
Step 2: Clean the SinAqua
™
Souper
™
• With a clean, damp cloth, wipe the top and all
sides of the Souper™. A mild soap may be used.
DO NOT immerse the Souper™ in water or place
it in the dishwasher.
DO NOT pour water into the chamber that is
intended for the tureen. Water will drain (see
Figure 5, page 4).
DO NOT use steel wool or abrasive cleaners.
CAUTION: DO NOT splash or pour water
onto the charger’s control panel or into the
intake/outlet vents. A possible shock hazard
may result and the unit may be damaged.
Step 3: Clean the Tureen
• Remove any product in the soup tureen.
• Wash the tureen in the sink using a mild soap and
water. The tureen is dishwasher safe.
DO NOT use abrasive cleaners on the tureen.