Specifications

MCD3000 Series
MG.15.A4.22 - VLT is a registered Danfoss trademark 11
Installation
Example 2. MCD3000 installed with a line contactor
and operated via a remote two wire start circuit with
reset push button.
Notes:
1. The MCD3000 must be in remote mode to
function with this circuit. Use the
[LOCAL/REMOTE] push button to switch between
local and remote modes.
2. Relay Output A must be programmed for the Line
Contactor function. Refer Par. 36 Relay A -
Function Assignment.
Example 3. MCD3000 installed with a bypass
contactor and controlled via a remote push button
circuit.
Notes:
1. The MCD3000 must be in remote mode to
function with this circuit. Use the
[LOCAL/REMOTE] push button to switch between
local and remote modes.
2. Relay Output C must be programmed for the Run
function. Refer Par. 38 Relay C - Function
Assignment.