Owner`s manual

In the event of a Possible Malfunction, your CookTek MagnaWave Cooktop

will display an Error Code on the LED Display. Please consult the following

table when encountering an Error Code.

Error Probable Cause Solution

Code

1 RTD (Temperature Sensor) Turn the unit off and let it cool. Unit will return to Normal

Temperature Too High mode in a short time.

2 RTD (Temperature Sensor) is not Reconnect or replace RTD

connected or is malfunctioning Service May be Required

3 Current Too High Possible Mechanical damage to coil or possible foreign

object on Cooktop. Service May Be Required

4 Electronics are Overheating Check Intake Vents. Listen for fan operation.

Service May Be Required

5 Input Line Voltage Turn unit off. Unplug. Without replugging unit, turn power

(From Power Outlet) Too Low switch to the ON position. Turn the unit off and plug back

into the power outlet. Resume normal operation. If the

problem persists, have an electrician monitor the line voltage.

6 Input Line Voltage Turn unit off. Unplug. Without replugging unit, turn power

(From Power Outlet) Too High switch to the ON position. Turn the unit off and plug back

into the power outlet. Resume normal operation. If the

problem persists, have an electrician monitor the line voltage.

7 Micro Communication Malfunction Turn unit off. Unplug. Without replugging unit, turn power

switch to the ON position. Turn the unit off and plug back

into the power outlet. Resume normal operation. If the

problem persists, Service May Be Required

8 Electronics Timing Incorrect Turn unit off. Unplug. Without replugging unit, turn power

switch to the ON position. Turn the unit off and plug back

into the power outlet. Resume normal operation. If the

problem persists, Service May Be Required

9 RTD (Temperature Sensor) Service is required to replace RTD

is Shorted

Two Hob (Two Position) Cooktops

Operation of the two hob (two position) Cooktop is exactly the same as the single

position Cooktop. Each position will have its own, independently controlled, On-

Off Control Knob and its own, separately controlled, SmarTemp button. It is not

necessary to turn on both positions for the Cooktop to function.

NOTE: For Proper operation a dedicated circuit should be used for each unit

installed. Each unit should be protected with a 30 minimum circuit breaker.