Owner`s manual

15 8
Manual Apogee 10334_A USINTL
● Use the Precision Control buttons to move the cursor to the desired setting and
then press the MODE/SELECT button.
● If you select “Set Temp Scale,” you will have two options to choose from -
Fahrenheit or Celsius. Again, use the Precision Control buttons to move the
cursor to your desired selection, and the MODE/SELECT button to confirm your
choice.
● The “Show Lock Info” will allow you to decide if
you want the key sequence to unlock the unit to
be visible when the user presses any button.
The unit will give you the option to hide or show
the key sequence, and then the unit will confirm
your choice.
● If you select the “Reset Defaults” option, the unit will then set the settings to
Fahrenheit and show lock feature.
● In order to lock the unit, you will want to press the
LOCK button three times. The unit will beep to
indicate that it has been locked.
● Anytime someone touches a key after the unit
has been locked, a message will appear on the
LCD Information Center reading “Locked.” The
unit will also remain in Locked ode even if the unit is turned off. The Lock mode
may be reset by unplugging the unit, but the unit must be on when doing this.
Simply unplugging the unit while it is powered off will not reset the Lock mode.
● The unlock sequence will be displayed as a factory default. If you change to
“Hide Unlock,” it will not be shown when the “Locked” messge appears on the
screen.
NOTE: Factory settings have the unit start in Fahrenheit and Show Unlock
mode. The standard factory unlock code requires teh lock button to be
pressed three times to unlock the unit.
● If a large amount of liquid is spilled onto the Apogee interface, it may respond to
the liquid on the interface. Wipe the liquid clean and allow the nit to sit for
approximately 2 seconds untouched and normal sensitivity to the buttons will
come back.
● Never heat an empty pan. It may damage the cooktop or cookware and
overheat the unit. When overheating occurs, an error code will flash on the
LCD Information Center and the cooktop will shut itself off automatically. When
the temperature returns to normal, the Cooktop will start to cook again.
● Remember to turn the cooktop off after each use.
● Keep the cooktop away from gas and electric ranges or open flames. Do not
place in the oven. If the surrounding air temperature is too high, the cooktop
will cease to function properly.
● Be sure to dry off the outside of the pan before use. Otherwise, as the pan
temperature rises, the water droplets on the outside of the pan may begin to
boil and apatter.
IMPORTANT INFORMATION
Operation of the two hob (two burner) cooktop is exactly the same as the single
position cooktop. Each position wil have its own, independently conrolled interface
and its own, separately controlled MODE/SELECT button. It is not necessary to
turn both positions on for the cooktop to function.
NOTE: For proper operation, a dedicated circuit should be used for each unit
installed. Each unit should be protected with a 30A minimum circuit breaker.
TWO HOB (TWO BURNER) COOKTOPS
DROP-IN UNIT DIMENSIONS
Dimensions
inches mm
A 20.67 525
B 16.16 410
C 15.13 384
D 3.74 94
E 3.63 92
F 0.25 6
G 19.64 498
H 0.36 9
J 19.81 503
K 15.30 388
L 4.74 120