Control Box Installation

Table Of Contents

Preventing Control Damage and Failure

• Insert Ethernet cable straight into RJ-45 connector

• Strain relieve cable so that connector entry remains

straight

• Route and protect cable to prevent damage/pulling from

behind/under counter installations/storage

• Do not over tighten

• Do not use lock-

washers

• Always mount vertically, do not mount horizontally

• Use included screws, Don’t use alternate hardware

• Clean with a soft damp cloth only

• CAUTION – Excessive water will cause failures

• Do not power wash

• Do not hose down

• Do not use excessive

water when cleaning

Control Boxes Are NOT Water Tight

Lock Washer Damage

Over Tightening Causes Failures

Installation

PAGE 1
Preventing Control Damage and Failure Control Boxes Are NOT Water Tight • • Clean with a soft damp cloth only CAUTION – Excessive water will cause failures • • • Do not power wash Do not hose down Do not use excessive water when cleaning Installation • • • • Always mount vertically, do not mount horizontally Use included screws, Don’t use alternate hardware Do not over tighten Do not use lockwashers Over Tightening Causes Failures • • • Lock Washer Damage Insert Ethernet cable straight into RJ-45 c