CONVOY TECHNOLOGIES USER MANUAL Wireless Video Camera MODEL:C7010 Please read this manual thoroughly before operating the unit, and keep it for further reference.
CONVOY TECHNOLOGIES Table of Contents 1. PRODUCT/SERVICE DESCRIPTION .............................................................................................. 2 1.1 1.2 2.3 PRODUCT CONTEXT ................................................................................................................. 3 USER CHARACTERISTICS ........................................................................................................ 3 OPERATION...............................................................
CONVOY TECHNOLOGIES 1. Product/Service Description 1.1 Product Context A battery powered wireless camera product that is specifically designed for tractor trailer vehicles and/or unmarried vehicles on the road. This camera system will provide a removable (magnetic) camera and monitoring solution to better assist drivers overcome the blind spots around their tractors and trailers. 1.2. User Characteristics Tractor Trailers are among the largest vehicles on the road.
CONVOY TECHNOLOGIES 4. Avoid dropping or striking this device. 5. Avoid using this device in enclosed spaces, areas with excessive vibration or subject to severe impacts. 6. Never puncture, scratch or use abrasive cleaning materials on this device. 7. Do not place cables where they may be pinched or stepped on. 8. Leave at least a 2”space between the unit and walls, or other objects to allow adequate air circulation around the unit. 9.
CONVOY TECHNOLOGIES RF 2.4GHz technology(POWER SUPPLY) +5~+12V TX (Current Consumption) TYPE:330mA, Max.400mA RX(Current Consumption) 200mA Environmental Specification) Operating Temperature) -10~+60 ºC Storing Temperature) -30~+85 ºC Operating humidity) 85%RH BASEBANGD SPEC.) POWER ON) Latency) Resolution) Frame Rate) 2SEC Max. RE TBD Max. SE/AV 100ms Max. RE TBD Max.
CONVOY TECHNOLOGIES (RF Impedance) 50Ω, Typ. Richwave 6758 standard specification . Features Multi-format MPEG encoder (MPEG Encoder format specification) - MPEG4 encoder 30 fps at 720x480, 25 fps at 720x576 - H.263 encoder: - JPEG encoder - Video pre-processing Multi-format MPEG decoder (MPEG Decoder format specification) 30 fps at 720x480, 25 fps at 720x576 - H.
CONVOY TECHNOLOGIES SDRAM controller, USB OTG controller, DMA controller and smart power saving mechanism to be a very powerful SOC platform. Some interfaces like video capture, LCD controller, TV encoder with 1-channel DA, audio AD/DA with digital filters, I2S, SPI are very suitable for audio / video applications. Product Overview 6763 chip (Richwave) RTC6763 is a 2.4GHz ISM band HDR (high data rate) FH (frequency hopping) transceiver.
CONVOY TECHNOLOGIES 3.2. Camera: Sensor: 1/3” Sony HAD color camera Resolution (pixel): 967x494 Lens: f=2.8mm Lens angle: 90º Horizontal; 65º Vertical Mini-Illumination: 0Lux (LED ON) IR LED: 12 pcs IR switch: available Night Vision Distance: 36ft. Video format: NTSC Audio: available 2.4GHz RF Technology Transmitting Distance: min.
CONVOY TECHNOLOGIES 3.3. IR board Microphone (12V,500uA) IR board:(12V,80mA) Camera board, IR Board use in C1800AHD 1) Input Voltage Range: Vmin, Vnom, Vmax 2) Input Current Range: Imin, Imax, Imax 3) Operating Temperature Range 4) Storage Temperature Range Spec :1)9V,10V,11V 2)10mA ,120mA 3)-20Ԩ~+70 Ԩ 4)-30 Ԩ ~+75 Ԩ 5) Light Sensitivity(Resistant 30~50KΩ) 6) Microphone Sensitivity(-58 ~ -54dB) 3.4 Receiver/Monitor 2.4GHz Technology 7" Monitor with Digital Panel Resolution: 800*R.G.
CONVOY TECHNOLOGIES CT-M7102 Monitor 1) Input Voltage Range: Vmin, Vnom, Vmax 2) Input Current Range: Imin, Imax, Imax 3) Operating Temperature Range 4) Storage Temperature Range Spec:1)11V,15V, 24V 2)110mA ,300mA 3) -20Ԩ~+70 Ԩ 4) -30Ԩ~+75 Ԩ LCD Monitor Brightness (min to max) (400 CD/M2) Speaker Output Level( 82dB ) 3.5. Battery: Lithium Ion 3s2p 18650, 10.8V, 5.8Ah; using Panasonic 18650 cells with 2.9Ah or 2450mAh capacity. Minimum 4 hours of battery life.
CONVOY TECHNOLOGIES Fe Iron 0.676 Cu Copper Mn Manganese 0.103 Mg Magnesium 0.203 Cr Chromium 0.553 Ni Nickel 0.247 Zn Zinc 0.614 Sn Stannum 0.429 Ti Tianium Pb Plumbum 0.0098 0.391 1.13 Note: No warrantee after end user removes the top 3.7. Magnets 2 magnetic surfaces with recessed areas in the enclosure material or fixed with brackets to accommodate the magnets (approx.
CONVOY TECHNOLOGIES 3.8. Wireless Antenna and connector: P/N#: YL2400-MMCXJW-10CM-M12-46 Frequency range: 2400-2500MHz Band width: 100MHz Vswr <=2.0 Gain: 2dBi Impedance: 50ohm Polarization: Vertical Max. Power: 40W ABS, dimensions: 46mm diameter, 16mm in height Cable: RG316—100mm Temperature range: -45C to 85C Connector: MMCXJW 3.9. LED indicator light P/N#8082.
CONVOY TECHNOLOGIES 3.10. Waterproof power button: P/N# 4126.8132.35 3 wire connection to battery 3.11. Waterproof Pairing button P/N#: 4126.8221.18 o o 3.12.
CONVOY TECHNOLOGIES Dimensions: 14mm round exterior 12mm round threaded 18.2mm depth into enclosure including power connector Rubber insulator between enclosure and connector Rubber plug for DC port 3.13. Charger, P/N# HYXF-12610A Constant voltage charger DC Input Voltage: DC12~24V Idle current ≤30mA,Input Voltage range at DC12-24V; Loading 1000mA, Output Voltage 12.6V DC Input Current (Input Current range at DC12V-24V), Idle current≥15mA. Normal operation input current≤0.
CONVOY TECHNOLOGIES 4. User Interface Requirements 4.1.Usability MAGCAM is extremely easy-to-use, however Convoy Technologies will provide User documentation Driver training 4.2.Performance Wireless transmission over 90 ft. Clear camera image on receiver monitor 4.3.Availability Operation: 15 minutes per cycle 5. Standards Compliance FCC IP65 6. Warrantee Warranty period will be valid of one year after shipping. In case of defects, please contact the manufacturer, distributor or retailer.
7. FCC Caution. (1)§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.