User`s guide

Chapter 1: Connections and Setup
Illustrations contained in this document are for representation only.
7
Rear Panel
Connector Description
15VDC Power connector
REBOOT EMTA Reset EMTA
TEL 1/2 and TEL 2 RJ-11 Phone set connector
ETHERNET Ethernet 10/100BaseT RJ-45 connector
USB USB Connector
CABLE F-Connector
Installing the Battery
This section provides information on installing batteries into the EMTA. Follow the steps below:
1. Ensure the power cord is unplugged.
2. Remove the battery cover on the rear panel. There are two battery compartments. You may
install a single battery into either compartment.