User manual

Chapter 5: Management with the CLU
147
Number of Physical Drives: 3
RAID mode: RAID 5
Stripe block size: 64KB
SMART check: enabled
Create Logical Drive now(y/n)?>y
6. Review the list. If you agree with the list, press Y and Enter. If you disagree
with the list, press N and Enter, then select Create New Logical Drive again.
In order to use this logical drive to read and write data, you must partition
and format it using the Host PC’s operating system.
Delete Logical Drive
Use this feature to delete an existing logical drive. Be careful when deleting
logical drives and be sure the logical drive you delete is the one you intended to
delete.
1. Press 3 and Enter to select Delete Logical Drive
****************Delete Logical Drive****************
Id Name Mode Size
---------------------------------------------------------
1 LogDrv1 RAID5 239 GB
2 LogDrv2 RAID3 198 GB
Select the Logical Drive ID to delete
Press R to return after finished>2
Delete Logical Drive 2(y/n)?>y
2. Type the ID number of the logical drive you wish to delete and press Enter.
3. To confirm deletion, press Y and Enter. To cancel, press N and Enter.
****************Delete Logical Drive****************
Id Name Mode Size
---------------------------------------------------------
1 LogDrv1 RAID5 239 GB
Select the Logical Drive ID to delete
Press R to return after finished>r
4. When you are done deleting logical drives, press R and Enter to return to the
Logical Drive Management menu.
Modify Logical Drive Parameters
Press 4 and Enter to access the Modify Logical Drive Parameters menu. If you
have more than one logical drive, specify the one you want by its ID number and
press Enter. Above the menu is a table of the current settings for this logical
drive.