Specifications

4-4
Cisco ONS 15200 Maintenance Manager Installation and Operations Guide
78-13764-01
Chapter 4 Alarms
Clip Active Alarms Screen
DWDM_LASERTEMP Indicates that the temperature of the laser transmitting
to the ONS 15200 network is outside the acceptable
temperature range.
Status
CLIENT_RXPOWER Indicates that the power input from the client
equipment is outside the acceptable power range.
Status
CLIENT_LASERTEMP Indicates that the temperature of the laser transmitting
to the client equipment is outside the acceptable
temperature range.
Status
CLIENT_LASERBIAS Displays the value of the current component added to
the modulation current in order to obtain a proper
operating point for the laser.
DWDM_LASERBIAS Displays the value of the current component added to
the modulation current in order to obtain a proper
operating point for the laser.
BOARD_TEMP Indicates that the temperature on the surface of the
CLIP module circuit board is outside the acceptable
temperature range.
Status
BOARD_POWER Indicates that the power of the CLIP module circuit
board is outside the acceptable range.
Status
DCN_QPPA
(protected channels only)
Indicates an error on the internal datacom link on the
A side of the network.
DCN_QPPB
(protected channels only)
Indicates an error on the internal datacom link on the
B side of the network.
DCN_QPP
(non-protected channels only)
Indicates an error on the networks internal datacom
link.
DCN_CAN Indicates an error on the Control Area Network
(CAN) bus.
POWER1 Indicates that the primary power input is outside the
acceptable range.
Status
POWER2 Indicates that the secondary power input is outside the
acceptable range.
Status
MISC_DAC Indicates a hardware fault relating to the
digital/analog converter (DAC) has occurred.
MISC_FLASH Indicates a hardware fault relating to the eeprom has
occurred.
MISC_INSTRUCTION Indicates an entity is trying to write to an unavailable
position.
Table 4-2 Environment Parameter Definitions (continued)
Alarm Name (Area) Definition
Alarm Type
(Name)