Manualshelf

Specifications

ManualsBrandsConverters.TV ManualsComputer equipment15200
41424344454647484950
3-14
Cisco ONS 15200 Maintenance Manager Installation and Operations Guide
78-13764-01
Chapter 3 CLIP Module Configuration
Clip Status
Step 2 To configure the alarm to report, clear the checkbox.
Procedure: Set Threshold Values
Follow these steps to set the CLIP module threshold available on the Clip Status screen:
Step 1 Double-click the desired threshold value. The Set Value window appears.
Step 2 Type the desired value.
Step 3 Click OK. The new threshold value takes effect immediately.
3.3.1 DWDM Side
The DWDM Side area of the Clip Status screen describes how the CLIP module is operating in relation
to the MCU and SCUs that make up the ONS 15200 network (Figure 3-6). Values for A RX Power, B
RX Power, Peltier Current, Laser Temperature, and Laser Bias are listed in this section. Table 3-10
describes the optical network parameters. All parameters except FDI Alarm and LOC can be
suppressed/inhibited.
Figure 3-8 shows the RX and TX power measurement points for the optical network interfaces on a CLIP
module.
Table 3-10 Clip Status - DWDM Side
Parameter Definition
FDI Alarm Displays whether the CLIP module received a Forward Defect
Indication (FDI) alarm.
LOC Displays whether the CLIP module received a Loss of Channel
(LOC) alarm.
A RX Power
(protected channels only)
Displays the values associated with the strength of the signal received
from the A-side MCU or SCU.
B RX Power
(protected channels only)
Displays the values associated with the strength of the signal received
from the B-side MCU or SCU.
RX Power
(non-protected channels only)
Displays the values associated with the strength of the received
signal.
Peltier Current Displays the values associated with the strength of the current to the
Peltier device. The Peltier device regulates the temperature of the
laser and maintains the wavelength of the transmitted signal.
Laser Temp Displays the values associated with the temperature of the laser that
transmits to the SCUs and MCU in the ONS 15200 network.
Laserbias Displays the laser bias current for the selected CLIP module.