Specifications

3-8
Cisco ONS 15200 Maintenance Manager Installation and Operations Guide
78-13764-01
Chapter 3 CLIP Module Configuration
Clip Summary
Table 3-7 Clip Summary Screen - DWDM SIde
Parameter Value
DWDM Status
• Normal—The selected CLIP module has not reported any alarms.
• Warning—The selected CLIP module has reported a condition that
exceeds a high warning or lower warning threshold value.
• Minor—The selected CLIP module generated a minor alarm based on a
condition that exceeds a high alarm or lower alarm threshold value.
• Major—The selected CLIP module generated a major alarm based on a
condition that exceeds a high alarm or lower alarm threshold value.
• Critical—The selected CLIP module generated a critical alarm based on a
condition that exceeds a high alarm or lower alarm threshold value.
FDI Switch Enable—If a protected CLIP module receives a Forward Defect Indication
(FDI) alarm, it will automatically switch to the standby path.
Disable—If a protected CLIP module receives a FDI alarm, it will not switch
to the standby path.
Caution Setting this parameter to Disable could be traffic affecting if an FDI
alarm is received.
Switch Mode (Displayed only if the CLIP supports fiber protection.)
Displays the switching scheme assigned to the selected CLIP module. The
operator can change this value.
The switching scheme selected determines how the ONS 15200 system will
behave if the input signal is lost on the active path. The “Procedure: Change
the Switch Mode” section on page 3-9 describes the procedure for changing
the switching scheme.
Active Path Displays the primary path on which the CLIP module is receiving. In protected
configurations, the active path can be either path_a or path_b.