Specifications

CHAPTER
3-1
Cisco ONS 15200 Maintenance Manager Installation and Operations Guide
78-13764-01
3
CLIP Module Configuration
This chapter describes how to view and modify the configuration of the Client Layer Interface Port
(CLIP) modules using the Maintenance Manager. Refer to the Cisco ONS 15200 Command Line
Interface Manual for information about parameters shown in the Maintenance Manager.
3.1 Clip Inventory
The Clip Inventory screen provides information about the selected CLIP module. The Clip Inventory
screen is divided into four areas: General, Board, RX (receive) transponder, and TX (transmit)
transponder. There are no editable fields on the Module Inventory screen.
3.1.1 General
The General area of the Clip Inventory screen displays inventory information about the entire CLIP
module (Figure 3-1). See Table 3-1 for general parameters.
Table 3-1 Clip Inventory Screen - General
Parameter Definition
Clip Element Id Displays the ID of the Client Layer Interface Port (CLIP) module.
ITU Channel Displays the channel where the CLIP module is configured to operate.
Channels are defined according to the standard ITU grid.
DCN Address Defines the Data Control Network address assigned to this module.
Clip Part No Displays the Cisco part number for the CLIP module.
Clip Serial No Displays the Cisco serial number for the CLIP module.
CLEI code Displays the CLEI code for the selected module.
NEC Part No Displays the Network Element Controller part number.
FW Revision No Displays the revision number of the firmware.