Specifications

1-7
Cisco ONS 15200 Maintenance Manager Installation and Operations Guide
78-13764-01
Chapter 1 Installation
Connecting to the ONS 15200 System
Figure 1-7 MCU Maintenance Manager connection
Step 5
When the two cables are connected from the laptop to the MA port, open Maintenance Manager.
Procedure: Connect the Laptop to an SCU
The following procedure describes how to connect a laptop with Maintenance Manager to the
ONS 15201 SCU. To connect to a desktop computer, contact the Cisco Technical Assistance Center
(TAC) at 1-877-323-7368.
Step 1 Insert the CAN board into an empty PCMCIA slot on the laptop computer.
Note If this is the first time the CAN board is being installed in the computer, the hardware driver
must be installed. To install the hardware driver, read the installation instructions included
on the Maintenance Manager CD-ROM.
Step 2 Attach the RJ-45 connector at the end of the MA CAN connector cable to the Maintenance Manager
connector on the SCU (Figure 1-8). The MA connection on the module is a standard RJ-45 connector.
laptop
computer
DRV CAN
cable
MA CAN
cable
CAN
board
(left port)
DB-9
connectors
NCB module
54804
CIM
MA port (RJ-45)