Service manual

Evolution FORD 7.3 Liter
7
NOTE: If stacking with the Juice/Attitude, we highly recommend only using the
TRANS ONLY level. Stacking power levels could result in vehicle damage, or adverse
running conditions, IE: high idle, DTC codes, etc.
PID Displays
The Evolution allows the user to view up to 4 PIDs at one time. There are 11 different
PIDs to choose from. Below is a list and description of each:
• RPM (revolutions per minute) – Engine speed.
• MPH (miles per hour) – Note: Dash display may be +/-3 MPH off from the digital
display due to mechanical differences in the spring, etc. used to control the gauge.
• BST (Boost Pressure) - PSI
• EGT (Exhaust Gas Temp) – Degrees F.
• EOT (Engine oil temperature) – Degrees F.
• TFT (Transmission fluid temperature) – Degrees F. (Automatic Trans ONLY. If
you have a manual trans, the value displayed will be incorrect)
• IAT (Intake air temperature) – Degrees F.
• BARO (Barometric pressure) – PSI
• BAT (Battery voltage)
• DTC (Diagnostic trouble code count)
Features
Diagnostics
The Evolution is also a powerful diagnostics tool. You can view any diagnostic trouble
codes (DTCs) your vehicle may have, which in turn allows you to fix them. It will also
allow you to turn off that annoying “Check Engine” light when the problem has been
addressed (no more expensive trips to the dealer for a diagnostics scan).
0-60 and Quarter Mile time
Another feature of the Evolution is the ability to determine your quarter mile times as well
as your 0-60 times. This is very easy to use and not all tuners have this feature.
Alerts
A feature that might come in handy is the alerts. If you would like to know when a certain
parameter, such as transmission temperature, reaches a certain value you could set an alert
to that value. As the preset value is reached, the Evolution’s screen will flash red and
display which alert was triggered and the current value for that particular alert parameter.