Service manual

Evolution FORD 7.3 Liter

8. Feed roughly 4 to 6 inches of cable through the dashboard. Mount the Pod onto

the dashboard (shown in Figure #6) with the end of the cable protruding

through the front of the Pod.

9. To secure the pod

: locate the metal brackets and the pod in your evolution

box. Note that the brackets are numbered and should be placed in the

appropriate numbered locations inside the pod. Use the permanent double

sided tape to secure the brackets to the inside of the pod, be sure that the

numbers match

TIP: Be sure to check the position of the brackets while the Pod is resting in

it’s desired location on the dash prior to attaching them to the Pod with the

double sided tape. This will help you avoid repositioning the brackets after the

tape has adhered.

Clean the pod location on the dash with hot soapy water and rinse, or use 70%

Isopropyl alcohol. Thoroughly dry. Attach the supplied Velcro to the bottom

of the mounting brackets in the pod. Leave the protective backing on the

bottom piece of Velcro, and test fit the pod so you have an idea of where you

want it. Once you have determined the appropriate positioning, remove the

backing paper from the Velcro, place the pod in it’s desired location, and

firmly press down on the brackets (through the front of the pod) to secure the

Velcro in place.

10. With the Pod secure, disconnect the cable at the OBDII port, and attach the

Evolution to the end cable which is protruding from the Pod.

Figure #6