Service manual

Ford 7.3 Liter Evolution

6. Connect the Edge Products connector to the OBDII port, and rout the cable up

over the bar behind the OBDII cable(Figure #3), then run the cable toward the

drivers side of the dash, be sure to keep it above the e-brake release lever.

Figure #3

7. With the driver’s side door open, remove the seal trim on the left side of the

dashboard (Figure #4) feed the end of the ODBII cable up behind the dash and

out between the seal trim and the side panel on the dash(shown in Figure #5).

Snake it up to the A-pillar of the vehicle and replace the access panel. The

cable should be protruding from the dashboard up along the A-pillar and be

able to move freely when Pulled

Figure #4 Figure #5