Service manual

Evolution FORD 7.3 Liter
13
The Evolution programmer connects to the diagnostic port of your vehicle. Follow these
steps to install the Evolution:
4. Begin by removing the access panel that is located just below the steering
wheel(figure #1).
Figure #1
5. Next, turn your ignition key to the OFF position. Locate the black diagnostic
(OBDII) connector (Figure #2) under the dash on the bottom right corner of the
access panel area. As you sit in your vehicle, it could be located right below
your right knee. Sometimes the cover to this connector will be labeled “Data
link.”
Figure #2
INSTALLING THE EVOLUTION
OBDII Port