User's Manual
Table Of Contents
- Version 1.0
- 3.1 Product Package
- 3.1.1 Basic Package Content
- 3.1.2 Product Specifications
- 4 Hardware Installation
- 5 Software Installation
- 5.1 Software Content of Shipment Package
- 5.2 PC Side Prerequisites
- 5.3 PC Side Libraries and API Document
- 5.4 Default Ex-Factory IP Settings
- 5.5 Changing IP Addresses
- 5.5.1 "Netfinder" Program Method
- 5.5.1.1 Hardware Setup
- 5.5.1.2 Software Setup
- 5.5.1.3 Search CS203 Board
- 5.5.1.4 Assign CS203 IP, Server IP and TCP Timeout
- 5.5.2 "CS203 GPIO" Program Method
- 5.6 Status Verification
- 5.7 Exception Situations
- 5.8 Finding a "Lost" CS203
- 6 Demo Applications
- 7 Middleware Connectivity
- 8 Software Upgrade
- 9 Regulatory Information
- Appendix A. RFID Basics
- Appendix B. Operation Profiles
- Appendix C. RF channels
- Appendix D. FAQ
- Appendix E. Common Mistakes
- Appendix D. Technical Support
CSL CS203ETHER-2 EPC CLASS 1 GEN 2 RFID INTEGRATED READER USER'S MANUAL, VERSION 1.0
5.4 Default Ex-Factory IP Settings
CS203 is shipped out with the following default ex-factory IP settings:
Reader IP address:
IP = 192.168.25.203
Target PC Server IP address and Subnet Mask:
IP = 192.168.25.141
Subnet Mask = 255.255.255.0
For the first connection to it, one can use a PC or a laptop, set it to the IP address of
192.168.25.141 with subnet mask 255.255.255.0, then run the CS203GPIO application that
comes with the CS203 package. On that application, one can then change CS203's own IP as
well as its targeted PC server IP address. This is described in the next section.
Copyright © Convergence Systems Limited, All Rights Reserved
20