User Manual

Table Of Contents

Turning the heater ON.

Note : When the heater is rst connected, it will

be in STANDBY position, with a blank display. To

start, press briey on the Heating STANDBY key.

The display will show the default comfort set point :

19.0°C (66°F).

The setpoint display is set to °C by default.

In order to display in °F : press the STANDBY key to

put the heater in STANDBY. Then, press the Mode

and + keys at the same time and hold for about 3

seconds. The display will show °F.

Repeat this operation to go back to °C.

Toshutofftheheatingfunction,pressbrieyonthe

Heating STANDBY key. The display will go blank.

Note : the heater still retains all settings in memory.

It remains in standby mode.

Shutting off heater operation.

Setting the desired temperature.

Turn the heating on. The display shows 19.0°C (or

66.0°F if set in Fahrenheit). Using the + and – keys,

you can raise or lower the setting as you wish by 0.5°

each time the key is pressed.

This is how you can adjust the thermostat to your

desired temperature (see example).

To conrm this comfort level, you may follow the

following procedure, preferably in the evening (no

suninuence):closethedoorsoftheroomwhere

the heater is located ; wait about one hour to allow

for the temperature to stabilize, then adjust the

setting up or down (+ or – keys) until the temperature

feels right. Allow another hour to verify that the

temperature has stabilized at the correct level.

Selecting a °C or °F display.

Mode