User Manual

Electrical Connection
R
PW
R
HEATER
B
B
G
POWER LINE
CANADA
C
PW
WITHOUT using a pilot wire
(PW)
.
CANADA
U.S.A.
B- Black G - Green R - Red W - White C - Copper PW - Pilote Wire
R
PW
R
HEATER
B
B
G
POWER LINE
C
R
PW
W
B
B
G
POWER LINE
C
U.S.A.
R
PW
W
HEATER
B
B
G
POWER LINE
C
PW
WITH the use of a pilot wire
(PW)
.
5.
The unit must be hooked up with the rectangular junction box already installed
in the wall.
1- Connect the ground wire (C) to the green wire (G) inside the connection box.
2- Connect the black (B) and red (R) leads from the heater to the electrical supply
wires (see diagrams below).
3- Youwillnd,onthepowercord,afourthpurplewire(PW)withasealedend.
This wire must not be used for the electrical connection.This wire will be used
only if the unit is connected to a CONVECTAIR "Programmer" control system.
4- Carefully place all wires back into the box, close and screw the cover.
5- Hook the CONVECTAIR unit onto the mounting bracket tabs with the unit
slightly angled towards you. Push the CONVECTAIR towards the wall until it is
engaged on both locking tabs.
CAUTION : This unit must be connected to a 240 volts or 208 volts circuit,
60 cycles. Disconnect power supply before making wiring connections to
prevent electrical shock or equipment damage.
CONVECTAIR recommends that this heater be installed by a qualied
electrician and in accordance with national and local codes.
- A rectangular junction box must be installed in the wall, prior to electrical
hookup. The box must be of appropriate size to receive the necessary electrical
connections and the 2 3/4’’ x 4 1/2’’ (70mm x 115mm) cover that is supplied with
the unit cable.
- To prevent short circuits and electrical shocks turn the power off at the main
panel before attempting the installation or any repairs.
- If the power cable is damaged it must be replaced by the manufacturer, an
approvedservicecenteroratechnicianwithsimilarqualications.