User Manual

Installation
2.
CAUTION: Convectair recommends that the Allegro be installed by a qualified
electrician, in accordance with national and local codes.
To reduce the risk of fire, do not store or use gasoline or other flammable vapors and
liquids in the vicinity of the heater.
Installation :
1- Free the mounting bracket by pressing and pulling
both locking tabs (Fig. B).
2- Relocate the mounting bracket to match the marks
with the holes for the bottom fasteners (Fig. C/D/E)
3- Make sure that the mounting bracket is level then
mark the 3 or 4 holes for fastening.
4- Place the mounting bracket and fasten it with
screws.
Locking
tab
470 mm
220 mm
150
Entraxe
258 mm
Longueur Appareil
A
Encombrement
de l’appareil
1500 => 2000W
mm
Figure C
Width
Overall
dimension
Bracket
Height
2000W
170
100
4’’
6 11/16’’ 10,2’’
28
B
104
258
2
A
A
500=>1250W
Bracket
750 => 1500W
4,1’’
1,1’’
10,2’’
7316 - ALLEGRO II - Figure C - Med
Power (W)
750 1000 1500 2000
Bracket 128mm 5’’ 208mm 8.1’’ 248mm 9,7’’ 405mm 16’’
Width 409mm 16,1’’ 489mm 19,3’’ 649mm 25,6’’ 849mm 33,5’’
A 140mm 5,5’’ 140mm 5,5’’ 226mm 8,9’’ 221mm 8,7’’
Height 470mm 18,5’’ 470mm 18,5’’ 470mm 18,5’’ 470mm 18,5’’
Figure B