User Manual

Table Of Contents

To change the Eco temperature :

When the display is in Eco mode, you have the option of choosing a set temperature.

The Eco temperature can be set at any value between the Frost Protection

temperature (7°C or 45°F) and the Comfort temperature minus 0.5°.

Select the Eco mode. Press and maintain the Mode key until the temperature

value starts to blink. Release the Mode key and adjust the temperature up or

downin0.5°stepsusingthe+or–keys.PressModetoconrmthesetting.

Note : the Eco temperature is relative to the Comfort temperature. If the Comfort

setting is changed, the Eco temperature will change automatically to maintain the

same difference between the two values.

Exceptions to the Eco Mode :

If the heater is connected to a Programming system, it will still respond to a Frost

Protection instruction.

Frost Protection setting : HG

In case of longer term absences (24hrs or more), the

HG mode will maintain the room temperature at 7°C

(45°F). You can reduce your energy consumption

while maintaining a safe minimum temperature.

To select the HG mode :

Press the Mode key until the display shows : HG.

Locking the heater controls.

The control pad can be locked from any Mode

selection to prevent tampering.

To lock the control : From any Mode setting, press

both the + and the – key at the same time and hold for

about 3 seconds. The display will blink to show that

the keyboard is locked.

Pressing any key when the keyboard is locked will

cause the screen to display «FF» and the heater will

not respond.

To unlock the keyboard, repeat the same procedure :

press and hold both + and – keys at the same time for

about 3 seconds.

Mode