Specifications

Wheelchair Assist Assembly Instructions
• Measure and mark each rear wheelchair down tube at 9 1/4”
from the floor. (see figure #1)
• Measure the distance between the wheelchair rear down
tubes. Use support tubes 601-0183 for 20” to 28” or support
tubes 601-0204 for 28” to 36”. (see figure #2)
• Align support tubes with receiver tubes in rear of Wheelchair Assist unit. DO
NOT TIGHTEN RECEIVER BOLTS. (see figure #3)
• Position Wheelchair Assist unit between wheelchair rear wheels with support
tubes facing forward. (see figure #4)
• One side at a time, place the clam
wheelchair down tube as seen in figure #4. Assemble clamp, bolts,
washers and nuts as seen in figure #5. DO NOT TIGHTEN.
• Position each clamp so that the top of the clamp is aligned with 9 1/4” ma
all clamp bolts. (see figure #7)
• Center Wheelchair Assist
Unit between wheelchair rear
wheels. Tighten receiver bolts
and lock nuts. (see figure #8)
• Check Wheelchair Assist
Unit for operation.
p into the support tube and around
rk on wheelchair down tube. Tighten