Instruction Manual

Installer Menu
Revision E Display and Menu Options 3-27
22
0 = Normally Open Edge 1 = Normally Closed
The default setting is edge sensor with Normally Open (NO) output. The optional setting of 1 requires an (NC) output.
EDGE COM
23
0 = Disable Free Exit 1 = Disable Close Timer
Configures the BLOCK EXIT input to disable either the Free Exit Detector function or, alternately, the Timer To Close function. The default setting disables the free exit detector. Note: The free exit is disabled when the gate is at its closed
limit. If the closed limit is not tripped, the free exit continues to work normally.
BLOCK EXIT COM
24
0 = Pause closing only 1 = Enable reversing to open
The default is for full reversal when the Outside Obstruction Loop is triggered. A setting of 0 causes the gate to only pause when triggered. Gate closure begins as soon as the loop is clear again.
OUTSIDE OBS LOOP COM
25
0 = Pause closing only 1 = Enable reversing to open
The default is for full reversal when the Inside Obstruction Loop is triggered. A setting of 0 causes the gate to only pause when triggered. Closure begins as soon as the loop is clear again.
INSIDE OBS LOOP COM
Table 3-2. Smart DC Controller - Installer Menu Functions (Continued)
Ref. No. *
Installer Menu
Setting Options
(
Bold = Factory Settings
)
Tasks and Explanations
Associated
DC Controller
Connections
Display
GC 0 NO CONTACT GATE EDGE OUTPUT
DT 0 FREE EXIT DISABLE FUNCTION
OR 1 REVERSE OUTSIDE OBS LOOP IR 1 REVERSE INSIDE OBS LOOP