Instruction Manual

Installer Menu
Revision E Display and Menu Options 3-23
5
5 1 through 10 1 = slowest speed 10 = fastest speed
Designate how quickly the gate opens. The range 1 through 10 varies the speed of the motor and the gate opening speed increases as you go up the number scale. A setting of 1 slows the gate travel to approximately 15 seconds. A setting of 10 speeds up gate travel to approximately 10 seconds. See Adjusting the Gate Speed.
(N/A)
6
5 1 through 10 1 = slowest speed 10 = fastest speed
Designate how quickly the gate closes. The range 1 through 10 varies the speed of the motor and the gate closing speed increases as you go up the number scale. A setting of 1 slows the gate travel to approximately 15 seconds. A setting of 10 speeds up gate travel to approximately 10 seconds. See Adjusting the Gate Speed.
(N/A)
7
0 = user settings 1 = reload factory settings
Globally restores all menu settings back to new operator status. Select setting 1 to return the operator to factory defaults. Note: If factory defaults are restored, the UL usage class,
handing, gate weight and length and any other modified menu settings will need to be configured again.
(N/A)
8
0 = solo operator 1 = Slave unit 2 = Master unit 3 = Sally Port A 4 = Sally Port B
Programs and establishes communication protocols when wiring two operators as dual gates in a Master/Slave or Sally Port configuration. This menu item appears if the sequenced gate (SG) is set at 0 (solo operator). When you assign one unit as the Master (or Sally Port A), you must configure the other as Slave (or Sally Port B) through the Installer Menu. See Master and Slave Menu Setup. Note: Use the most up-to-date version of S.T.A.R.T. and
make sure both operator’s have the same software version loaded on the SDC. Press the RESET button to display the version of software on your operator.
3-wire shielded cable to DUAL GATE input terminals. Connect Dual Gate COM (Gate 1) to Dual Gate COM (Gate 2). Pair wires: A - A, COM - COM, and B - B
Table 3-2. Smart DC Controller - Installer Menu Functions (Continued)
Ref. No. *
Installer Menu
Setting Options
(
Bold = Factory Settings
)
Tasks and Explanations
Associated
DC Controller
Connections
Display
SH 0 GATE HANDING OS 5 OPEN SPEED
SH 0 GATE HANDING CS 5 CLOSE SPEED
FD 0 (OFF) FACTORY DEFAULTS
DUAL GATE <MASTER>
DG 0 (OFF) DUAL GATE