Instruction Manual

ONON
514514
GDEGDE
ONON
514514
GDEGDE
ONON
514514
GDEGDE
ONON
514514
GDEGDE
ONON
514514
GDEGDE
ONON
514514
GDEGDE
ONON
514514
GDEGDE
PowerPower
DetectDetect
Loop FailLoop Fail
ResetReset
22
11
00
00
SENS.SENS.
LEVELLEVEL
BOOST ONBOOST ON
PULSEPULSE
FREQ.FREQ.
00
00
OFFOFF
PRESPRES
22
11
11 22 33 44 55 66
SAFETY Loop
detector
PHOTO
Beam
Relay (COM)
Relay (COM)
Relay (N.C.)
Relay (N.C.)
MULTIPLE SAFETY DEVICES
CONNECTIONS
Multiple devices installed together must be connected in series . the normally closed
(N.C.) dry contact from accessory relay. efore installing the accessory devices, remove
the black wire jumper from the terminal position
SAFETY “ ”
SAFETY
Locate
each Also, b
on the terminal strip of the control board.
From Accessory #1 to Terminal Strip
Relay Com to 24V-COM
From Accessory #2 to Terminal Strip
Relay N.C. to SAFETY
From Accessory #1 to Accessory # 2
Relay N.C. To Relay Com
This diagram is for the relay wires of the safety devices, two wires to the terminal
strip (one from each device) and two wires to the orange wire nut.
Wire nut
Terminal strip
Safety wire connections
14
AB
Remove black jumper
from SAFETY when
a safety device is
installed.