User Manual

Repeat steps 7 and 8 for up to ten devices per directory code. After the last device has been programmed,
press or key to return to the program selection screen.
TRANSMITTER/CARD PROGRAMMING
26
Icon Page
STEP
6
005 TRANSM/CARD#1:
___-_____ (S) SCAN
To complete entry, press the key to return to the program selection screen.
To program RF devices ( i.e. transmitters/cards etc.) continue on to Step 7.
NOTE: To enable the transmitter/card programming feature, you must insert the communicator card
in the “backup” slot before you turn on unit. (refer to “Memory Card Installation” section)
005 TRANSM/CARD#2:
___-_____ (S) SCAN
005 TRANSM/CARD#10:
___-_____ (S) SCAN
•
•
•
•
STEP
7
STEP
9
NOTE: The time zones and restrictions associated with transmitter/card codes can only be programmed remotely using the
EMS modem software.
STEP
8
C
V
B
N
M
’
X
Z
A
Q W
E
R
T Y U I
0
7
4
1
2
3
5 6
8
9
O
P
S
D F
G H J
K L
SPACE BAR
EX T
HELP
ROGRAM
ERASE
ENTER
BACK
SPACE
SH FT
STAND-ALONE
RECEIVER
Model ERRB485
Processor
Touch the card to the card reader
to activate remote device
Model ECR485B
Press button on transmitter to activate remote device
e
r
(fig a.)
(fig b.)
Use keys to view and
program up to 10 transmitter or card
codes associated to the directory code.
To program a transmitter or card code
you may enter the code manually using
the keypad or you may scan the
transmitter/card code.
To scan a card code, press and release
the key and activate the card
as shown in fig a.
To scan a transmitter code, press and
release the key and activate
the transmitter as shown in fig b.
S
S