User Manual

ARM LAYOUT & OPERATOR
PLACEMENT CONTINUED
Hinge point
Bracket
Bracket
Center shaft of
Operator
3
Measure distance from the Y
Z.
point
And point Say distance is 60”,
divide this number by 2,which =30”.
This is the length of primary arm in
next drawing.
PLEASE BE EXACT!!!
4
+
This ARM section is half the
distance between point
and point as shown above.
Y
Z
IT MUST BE EXACT!!!
This pipe does not need to
be measured after primary
arm is installed this pipe
makes up the balance of
arm.
PRIMARY ARM SECTION
CENTER OF
BOLT AT FIRST
HINGE POINT
CENTER OF
SHAFT ON
OPERATOR
X
X
Point Y
Point Z
+
9