User Manual

29
This is a normal loop layout. Remember when connecting to
an All-O-Matic circuit board you use the
for your safety loop detector and
from the exit loop. You must twist your
wires from your exit point of the saw cut all the way to the
circuit board, no exceptions.
normally closed
contacts normally
open contacts
SWINGER LOOP LAYOUT
Outside Safety loopOutside Safety loop
Inside Safety loopInside Safety loop
Center Phantom loopCenter Phantom loop
5FT5
FT
5FT5
FT
5FT5
FT
5FT5
FT
5FT5
FT
5FT5
FT
Gate in open
position
Gate in open
position
Exit loopExit loop
1/4 IN1/4 IN
1 1/2 IN
TWISTED 6
TURNS
PER FOOT
WIRED IN
SERIES
WHEN USED