Owner manual

These high quality loop detectors are for use with the
OmniControl™ Board available on Chamberlain Elite’s
commercial line and other enabled controllers. With
Chamberlain Elite's proven design and integration tech-
nology, these component detectors will make installation
of loop detection systems simple.
845 Larch Avenue Elmhurst, Illinois 60126-1196
www.chamberlain.com
Warning: Chamberlain Elite does not warrant nor assumes liability for #AELD Loop Detectors installed in non Chamberlain Elite enabled controllers.
f
or the OmniControl™ and other Chamberlain Elite
#AELD enabled controllers.
#AELD Plug-In Loop Detection
now with BOOST CONTROL
01-50969B
The loop itself must be a continuous length of wire without any breaks or
splices. The loop wire can be 14, 16 or 18 gauge stranded wire with
either a cross-linked polyethylene (XLPE) or polyester insulation.
Wrap the loop wire in the loop slot using a wooden stick or roller to
insert the wire to the bottom of the saw slot until the desired number of
turns are reached. (Caution: do not use a sharp object) Each turn of wire
must lay flat on top of the previous turn.
The wire must be twisted a minimum of 6 turns per foot from the end of
the feeder slot to the detector to minimize noise or interference. If a splice
is required in the feeder cable, solder each splice and protect with a
moisture proof seal.
Apply the sealant. The sealant selected should have good adhering properties
with similar contraction and expansion characteristics as the pavement
material.
Loop Installation
10 feet - 13 feet
Loop
Perimeter
Important
Number
of Turns
4
314 feet - 26 feet
27 feet - 80 feet 2
181 feet and up
1/8" to 1/4"
Saw Slot
Feeder Slot
End of Saw Cut
1
The wire is continuously wound in
the loop saw slot for the required
number of turns. One turn shown.
(Refer to table above)
The wire must be twisted together
6 twists per foot from the end of
the saw cut to the detector
4
1/8" to 1/4"
Saw Slot
Road Surface
Sealant
Loop Wire
(3 Wires Shown)
Min 1"
2
5
3
Remove Sharp
Inside Corners
For Technical Support: 1-800-528-2806
5
4
3
© 2005 the chamberlain group, inc. – all rights reserved