Manual

1.3 Mounting the Operator

1. Remove the operator from the shipping carton.

2. Remove the cover from the operator.

3. It is advisable to remove the conduit knockouts (as required) prior to mounting the

operator onto the operator base plate.

1.3.1 Post Mounted Operators

1. Place the operator on its side and remove 6 bolts and 4 nuts from the bottom frame

(Figure 8).

2. Gently place the operator on the mounting post assembly being sure to align all 6 nut

plates and the 4 mounting bolts.

3. Replace the 6 bolts and the 4 nuts removed in step 1 to secure the operator to the

mounting post assembly.

4. Route conduits into the operator at this time.

Figure 8

Output

Shaft

Output

Shaft

Nut Plates

Operator Frame

Remove Bolts

Remove Nuts

Page 20 6300-065-E-4-08