Instruction Manual

Install Warning Signs

1.5 Mounting Control Box with Conduit

This DoorKing Swing Gate Operator is shipped with two

warning signs. The purpose of the warning sign is to alert

uninformed persons, and to remind persons familiar with the

gate system, that a possible hazard exists so that appropriate

action can be taken to avoid the hazard or to reduce exposure

to the hazard.

Cover the exposed holes on top of

the actuator with the aluminum tape.

Do not cover the holes on

the bottom of actuator.

Position the control box on the wall, close enough to the actuator arm so the primary actuator cable can be easily routed inside

the box. Secure the control box to the wall with appropriate hardware (not included). Control box has predrilled mounting holes.

All power and control wires should be routed to control box in conduits with sweeps. Never run high voltage and low voltage

wires in the same conduit, keep them in separate conduits.

Permanent wiring must be installed to the operator as required by local electrical codes. It is recommended that a licensed

electrical contractor perform this work. Check local building codes prior to installing any permanent wiring to ensure all wiring

and connections comply with local electrical code requirements.

Coaxial Cable Antenna Kit

(Sold separately)

Primary

Actuator

Cable

Secondary Actuator Conduit

Control Box must be

properly grounded.

Power Conduit

Loops Conduit

• Use only sweeps for conduit bends. Do not use 90° elbow connectors as this will make wire pulls very difficult and

can cause damage to wire insulation.

• Permanently install the

supplied warning signs in

locations so that the signs

are visible by persons on

both sides of the gate.

• Use appropriate hardware

such as wood or sheet metal

screws (not supplied) to install

the warning signs.

Cover Holes on Top

6002-065-M-6-08