User/Installation Manual ADVANTAGE DKE MODEL 26-100L “Your Partner in Access Control” www.americanaccess.
AAS 2Year Limited Warranty What item(s) this warranty applies to: American Access Systems “Advantage DKE” access controls. What is covered: Any defect in materials or workmanship. For how long: Two years from date of purchase. What we will do: If your AAS product is defective and returned within 2 years of the date of purchase, we will repair it or, at our option, replace it at no charge to you. If we repair your AAS product, we may use new or reconditioned parts.
PARTS CHECKLIST Enclosed with this box you should have the following items.
STEP 1-MOUNTING THE UNIT Page 3 tells you what tools and instruments you will need to install your unit and presents a parts check list. Make sure to have all the tools listed. Upon opening the box, check off the items enclosed with the unit. If any items are missing from your unit, contact American Access Systems immediately. Mounting the unit to an AAS gooseneck (18001) or double height (18003)pedestal Locate the four carriage bolts and four hex nuts found inside the unit box.
OP E R ATOR WIR ING DIAG R AM White/White connect to operator secondary power. (12 to 24 volt) Orange/B rown connect to operator open/close circuit. (B lue not used) OP E R ATOR HOOKUP STEPS (A). Your DKLP control unit operates on 12 to 24 volts AC or DC. Measure the voltage from the power source to make sure it falls within these tolerances. Locate the two white wires on the circuit board and with the power off connect them to a constant power supply. (B).
THE * AND # KEY The * and # keys serve specific functions while in the idle or program mode. The * key is always the clear key. You should use this key if you make an entry error. The # key also serves as the clear key in the idle mode. In the program mode however, it serves as the exit key and will at any time when depressed, exit you from the program mode. PROGRAMMING A person desiring a access to the program mode will enter the present MASTER CODE.
“4” Sub-Mode 4 (Set Relay Output Time from 1/2 to 9 seconds) To set the relay output time in seconds enter the PRESENT MASTER CODE, followed by 4, and then the relay output time in seconds. NOTE: “0” = 1/2 seconds. (PRESENT MASTER CODE) + 4 + (RELAY OUTPUT TIME) Should you make an entry error, simply press the * key and re-enter the correct data. You may enter any single digit value corresponding from 1/2 to 9 seconds of total length output time.
30 - 023 Board Layout Reset Button Processor Power Harness Relay Page 8 American Access Systems / Security Brands, Inc.
MASTER CODE ____________ Page 9 American Access Systems / Security Brands, Inc.
Customer Service and Tech Support Customer Service: 303-799-9757 Customer service is available free of charge. Hours are 8:00 a.m. to 4:30 p.m. MST. If you call, please have your Model and Serial Number to help our Technicians assist you. E-Mail: customerservice@securitybrandsinc.com Technical Support: 303-799-9757 Technical support is available free of charge. Hours are 8:00 a.m. to 4:30 p.m. MST. If you call, please have your Model and Serial Number to help our Technicians assist you.
Notes Page 11 American Access Systems / Security Brands, Inc.
“Your partner in access control” www.securitybrandsinc.
