Owner's manual

1603-065-N-7-11

Plates MUST lay flat and even on concrete.

Extension

Tunnel Plate

Spike

Tunnel Plate

3.1 Lay Sections on Concrete Pad

SECTION 3 - AUTO SPIKE SYSTEM INSTALLATION

The operator and auto spike system must be installed on a flat and level concrete pad with a minimum 6 inch depth (Check local

building codes for restrictions). Reinforced concrete recommended.

Lay all tunnel plates on the concrete pad in their final configuration. Plates must

lay flat on the concrete and be level with each other. DO NOT anchor them to the

concrete at this time.

Examples: Sections can be connected in different configurations for specific applications.

It is recommended that the “Spike” sections not exceed 12 feet for proper operation.

2 Ft Extension 2 Ft Extension 3 Ft Spikes 3 Ft Spikes 3 Ft Spikes 3 Ft Spikes End Cap

2 Ft Extension End Cap

2 Ft Extension 3 Ft Spikes 3 Ft Spikes 3 Ft Spikes End Cap

2 Ft Extension

2 Ft Extension 3 Ft Extension 3 Ft Spikes End Cap

Extension shaft is the same length as its tunnel plate

and WILL slide back and forth for adjustment.

Spike shaft is recessed 1/2 the length of Connector Shaft on

each end and WILL NOT slide back and forth in its tunnel plate.

Operator shaft extends 1/2 the

length of the connector shaft.

Connector

Shaft

Spike shaft restraining guide.

Extension Shaft

Tunnel Plate

Traffic Direction

3 Ft Spikes 3 Ft Spikes 3 Ft Spikes 3 Ft Spikes

3 Ft Spikes 3 Ft Spikes