User Manual

Page 32
January, 2007
620/640 Operator And
624BLD Control Panel Installation Manual
Logic
MASTER/SLAVE WIRING INSTRUCTIONS
To wire two barriers as a Master/Slave
configuration, follow the wiring diagram
below and program the barriers as follows.
MASTER: Program the logic as needed and
the parameters as follows:
OUT2:
OUT3:
SLAVE: Program the slave logic into the “C”
Mode it should look as follows:
=
= =
= =
THE 624 BLD CONTROL PANEL INSTALLATION INSTRUCTIONS
Figure 5C. 624 BLD Master/Slave Wiring
Diagram