User's Manual

Specifications:
Transmitter
Frequency: 433.92 MHz
Dimensions: 1.25 x .875 x .25”
Security Code Method: Code Hopping
Battery Life: 60,000 cycles
Operating Temperatures: -4°F to 122°F
Receiver
Frequency: 433.92 MHz
Dimensions: 2.25 x 1.25 x .75”
Security Code Method: Code Hopping, up to 12 transmitters
Operating Temperatures: -4°F to 122°F
Electrical Rating: 100,000 cycles at 2 Amps. 24 VDC/120 VAC
Input Power: 24 VAC, 24 VDC or 12 VAC, 12VDC
Output: 2 relay outputs: 1 NO 1 NC
Programming the receivers output activation time:
When the receiver is activated, its outputs will stay in the minimum activation state for approximately 1.5
seconds (default). This time can be adjusted to stay in the activation state for up to 4 hours. See below
to adjust the receiver's output activation time.
1. Press the receiver's programming button for 4 seconds and release. The LED should be solid red. The
receiver is in the activation time programming mode.
2. Press and release the transmitter button.
3. When the desired time has elapsed (up to 4 hours) press the transmitter button again. The receiver's
LED should blink green several times. When the procedure has ended, the LED should be blinking red.
Deleting transmitters from the receiver's memory:
See below to erase the receiver's memory of all previously learned transmitters. NOTE: Deleting
previously learned transmitters does not change the receiver's output activation time.
1. Press the receiver's programming button for at least 8 seconds until the receiver's LED starts blinking
green, then release the programming button. The LED should now be blinking red.
2. The receiver's memory is now cleared.
FCC ID: SU7TRADCS433
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.