User's Manual

ManualsBrandsControlled Entry Distributors ManualsElectronicsRemote Controller

1/4

6-1621766 rev00 06/06/2017

The Transmitter Solutions transmitter is a transmitter operating at 915MHz.

It has been designed for the control of automatic closing systems and anti-

burglar systems, thanks to its very high security coding system (Rolling code).

The code sent by the transmitter changes at each activation, avoiding any

scanning and copying risk. A special algorithm allows to keep synchronized

transmitter and receiver.

The two AAA alkaline batteries of the transmitter have a shelf life of about 24

months.

The product fully complies with Part 15 of FCC Regulations.

1 CHANNEL TRANSMITTER

TRAHANBUT915-AL

Thank you for choosing this Transmitter Solutions product.

Please read this manual carefully before installing the product.

CONTENTS

1. TRANSMITTER OVERVIEW

1A - General information

1B - Technical specication

1C - Main components

1D - Status of the transmitter

2. NUMBERING

3. PROGRAMMING

4. OPERATION

5. BATTERY ACCESS

6. TROUBLESHOOTING

1A - General information

Summary of content (5 pages)

PAGE 1
CHANNEL TRANSMITTER TRAHANBUT915-AL Thank you for choosing this Transmitter Solutions product. Please read this manual carefully before installing the product. CONTENTS 1. TRANSMITTER OVERVIEW 1A - General information 1B - Technical specification 1C - Main components 1D - Status of the transmitter 2. NUMBERING 3. PROGRAMMING 4. OPERATION 5. BATTERY ACCESS 6. TROUBLESHOOTING 1A - General information The Transmitter Solutions transmitter is a transmitter operating at 915MHz.
PAGE 2
1B - Technical specifications Operating frequency: Number of inputs: Battery: Battery life: Security Code: Number combinations: Operating temperature: Overall dimensions (transmitter): Overall dimensions (battery case): Weight: Weight with batteris: 915 MHz 1 2 x 1,5V Alkaline battery (AAA) 18 - 24 months Rolling code 2exp256 23°F - +131°F (-5°C - +55°C) 2,13’’ x 0,98’’ x 0,39’’ (54 x 25 x 10 mm) 2,00’’ x 0,94’’ x 0,47’’ (51 x 24 x 12 mm) 0.64 oz. (18,2 gr.) 1.45 oz. (41,2 gr.
PAGE 3
2 - NUMBERING Each transmitter is manufactured and sold with a different factory-set serial number. 3 - PROGRAMMING The transmitter must be programmed into your system memory. Your own installer or reseller will provide you the necessary instructions for your system. 4 - OPERATION A- Connect the NO button to the inputs cables (2 black cables). B- Firmly depress the button until the red LED illuminates. C- After the LED has illuminated, release the button.
PAGE 4
Transmitter Solutions - Type: TRAHANBUT915-AL FCC ID: SU7HANBUT915-AL This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 5
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 & 74 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.