User's Manual

3/4
6-1621765 rev00 02/03/2016
2 - NUMBERING
Each transmitter is manufactured and sold with a different factory-set serial
number.
3 - PROGRAMMING
The transmitter must be programmed into your system memory.
Your own installer or reseller will provide you the necessary instructions for
your system.
4 - OPERATION
A- Connect the NO button to the inputs cables ( 2 black cables).
B- Firmly depress the button until the red LED illuminates.
C- After the LED has illuminated, release the button.
If the device you are attempting to activate does not respond, repeat steps B
and C or consult section 6 ( Troubleshooting ) of this manual.
5 - BATTERY ACCESS
To access the battery, please refer to the push plate manual.
Slide out the old batteries and replace them with the new ones (AAA alkaline
battery) respecting the polarity.
NOTE: Please dispose of the batteries properly according to local laws and regulations.
Test proper battery installation by verifying that the red LED illuminates when the
button is pushed.
6 - TROUBLESHOOTING
PROBLEM SOLUTION
The system does not receiver the
transmitter signal.
The transmitter LED will not light
Replace the transmitter
batteries
The system does not receiver the
transmitter signal.
The transmitter LED is ON
Check to verify the transmitter is
programmed into your sistem
The operating range is reduced
Replace the transmitter
batteries