COD. SU7GOBIO/1.0 GOBIO BIOMETRIC TRANSMITTER FOR OPERATING WITH MOTION RECEIVERS. More information in www.jcm-tech.
COD. SU7GOBIO/1.
COD. SU7GOBIO/1.
COD. SU7GOBIO/1.0 GOBIO FINGERPRINT PROGRAMMING First enter in configuration mode. Pass the fingerprint to programme 5 times. The equipment will remain in configuration mode. This process must be repeated for all the desired fingerprints to programme. The first channel selected will be used by default channel. All the programmed fingerprints will be MASTER FINGERPRINTS by default. For the NOT MASTER FINGER-PRINTS programming, see clause MASTER FINGERPRINTS / NOT MASTER FINGER-PRINTS CONFIGURATION.
COD. SU7GOBIO/1.0 GOBIO ERASING THE MEMORY To erase the memory, the device must be in configuration mode. A) ERASING ONE FINGERPRINT B) TOTAL RESET Keep pressed the two pushbuttons and a serial of fast beeps will be heared, indicating that the memory has been totally erased. The equipment remains in configuration mode. To exit configuration mode, wait 10 seconds without doing any action, or closet he protective cover, the device will exit configuration mode, and the three leds will go off.
COD. SU7GOBIO/1.0 GOBIO The default-programmed channel will be sending for the fingerprint used. B) PUSHBUTTON ACTIVATION + BIOMETRIC VALIDATION OPERATING: C) NORMAL TRANSMITTER OPERATING If there are not fingerprints programmed in the device, this will operates as a normal transmitter pressing any of the buttons. If the fingerprint is not recognised, the orange led will be at ON and two beeps will be heard.
COD. SU7GOBIO/1.0 GOBIO A: Start swipe with the top knuckle above the sensor strip. B: Swipe finger straight down keeping firm contact with the sensor. C: The scan should end at the tip of finger. INCORRECT D: Do not bend finger during swipe as this will only scan the tip of your finger. E: Swipe fingerstraight down, not at an angle. F: Swipe flat, not tilted or rolled to one side. How to avoid damaging the biometric reader? Keep always the protective cover closed when the transmitter is not used.
