User's Manual

4. Enter “01” for the number of user code.
(e.g.”03” for Third User Entry Code …etc.)
5. Enter the new “User Enter Code”(4 digits).
6. Press the “*” button, the multi-color status LED flashes 3 times with a green
color, Means the code is accepted.
7. If multi-color status LED flash 3 times with Red color, Meant code repeated.
z Delete the programmed User Enter Code
1. Enter the “Master Code”(default is 1 2 3 4 ).
2. Press the “*” button.
3. Enter “2” for delete a user code.
4. Enter “01” for the number of user code.
(e.g.”03” for Third User Entry Code …etc.)
5. Press the “*” button.
z Multi-color status LED
z Orange – Key depress
z Green – enter correct code & transmitting
z Green – Programming mode
z Red (flash 3 times) – Error during programming mode
z RF transmit time setting
RF transmit 0 second (Just only O/P active 3 second)
RF transmit 1 second
RF transmit 2 second
RF transmit 3 second
RF transmit 4 second
RF transmit 5 second
RF transmit 6 second
RF transmit 7 second