User's Manual

Keypad300318 user manual

The keypad will shut down for approx. 40 seconds if your entry code is not correct

within a string of 18 digits. This will discourage an unauthorized person from trying

use random numbers to access your property.

z Programming the Keypad

1. Setting the Jumper J4.( is 3 state 9 Port is 2 state 10 port)

2. Setting the DIP switches to match with the receiver.

3. If Receiver have only 2 positions (ON & OFF), set the switches of the

keypad to “+” for “ ON or CLOSE, and “—“ for OFF or OPEN (Do not use

“-“ center position.).

z Return to default setting

1. Disconnect the power by remove the battery.

2. Press “ 1” , ” 4”, ” 7” keys simultaneously.

3. Power up the keypad again.

4. Release “ 1” , ” 4”, ” 7” keys.

5. Return to default Master Code 1234 .

6. Clean all User Entry Code.

z Programming the Master Code

1. Enter the “Master Code”(default is 1 2 3 4 ).

2. Press the “*” button.

3. Enter “1” for change code.

4. Enter “00” for Master Code.

5. Enter the new “Master Code”(4 digits).

6. Press the “*” button, the multi-color status LED flashes 3 times with a green

color, Means the code is accepted.

7. If multi-color status LED flash 3 times with red color, Meant code repeated.

z Programming the User Enter Code

1. Enter the “Master Code”(default is 1 2 3 4 ).

2. Press the “*” button.

3. Enter “1” for change code.

PAGE 1
Keypad300318 user manual The keypad will shut down for approx. 40 seconds if your entry code is not correct within a string of 18 digits. This will discourage an unauthorized person from trying use random numbers to access your property. z Programming the Keypad 1. 2. 3. Setting the Jumper J4.( is 3 state 9 Port is 2 state 10 port) Setting the DIP switches to match with the receiver.
PAGE 2
4. 5. 6. 7. Enter “01” for the number of user code. (e.g.”03” for Third User Entry Code …etc.) Enter the new “User Enter Code”(4 digits). Press the “*” button, the multi-color status LED flashes 3 times with a green color, Means the code is accepted. If multi-color status LED flash 3 times with Red color, Meant code repeated. z Delete the programmed User Enter Code 1. 2. 3. 4. 5. Enter the “Master Code”(default is 1 2 3 4 ). Press the “*” button. Enter “2” for delete a user code.
PAGE 3
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.