User's Manual

3
(Old Access Code) (New Access Code)
Frequency
Output Code
Indicator
LED
Dip Switch
Keypad
LED
S2
S3
8 Port
310 MHz 300 MHz
10 Port
1
1
2
2
3
3
LED 4 LED 2
LED 5 LED 3
V2
V3
S3
2-3
DIP
TO CHANGE TO RADIO CODE:
DIP switch must be set to match the code on the 10 position switch on
the garage door operator receiver.
TO CHANGE TO ACCESS CODE:
# # 1-2-3-4 1-3-5-7 #
LEDS:
Indicator LED:
Indicator LED ON:
Into change access code mode
Indicator LED blink
The code is enter incorrectly
Keypad LED:
Keypad LED blink
Access code passed
Keypad LED blink rapidly 5sec
Battery low (7V)
PRESET FACTORY CODES:
Access code : * - 1 - 2 - 3 - 4 - #
(Note: To reset the access code
remove 9 volt battery form unit,
Depress any key on the keypad
and wait 5 seconds before installing