User's Manual

• The transmitter module built into the DOLGDO318LIPW4 is a 4-channel, rolling

code transmitter.

• As each transmitter has a unique serial number, no further action by the user is

required outside of programming the receiver to recognize the rolling code signal.

• Refer to your receiver’s instruction for how to program the keypad signal into

your receiver.

• When the receiver instructions indicate the need to press the transmitter button,

you will need to enter your PIN into the keypad to initiate a transmission.

PROGRAMMING THE DOLGDO318LIPW4

Default PIN: 1 2 3 4

Changing the PIN

LED Guide:

Indicator LED:

ON Entered into change access code mode

BLINK Code entered incorrectly

Keypad LED:

BLINK Access Code correct

Accessing a

specific channel

#, #, PIN: 1 2 3 4, New PIN: __ __ __ __ , #

#, PIN: __ __ __ __, Channel:1-4

Use this sequence when accessing a different

channel is desired for multi-channel receivers.

Example:

#, 5 5 5 5, 2 accesses channel 2

#, 5 5 5 5, 3 accesses channel 3

#, 5 5 5 5, 4 accesses channel 4

(Note: To reset the access code remove 9 volt battery form unit, Depress any key on

the keypad and wait 10 seconds before installing battery.)