User's Manual

CDVI Wireless SPA VIA PIAVE, 23- 31020 S.PIETRO DI FELETTO (TV) – ITALY
Tel. [phone] R.A. – Fax. [phone] I. 03023780269
internet: www.erone.com - e-mail: [e-mail]
TCF-157 07/2015 Pag 8 of 19
4.2 Stand-by transmission
This is a function useful when the S/N of the keypad must be memorized into the corresponding
receiver.
Sometimes the receiver and the keypad are already fixed, may be far each other, and so it
becomes difficult to enter into the memorization procedure of the receiver and then dial the user
code and get the RF signal within the time-out the receiver
So has been created a new option, called “Stand-by transmission”.
The concept is that:
- 1) I enter in a special menu on the keypad, I preset the transmission but I don’t make the RF
transmission and I set the keypad into a stand-by status with 30 sec. of time-out,
- 2) I enter into the receiver memorization menu of the desired relay.
- 3) I come back to the keypad and I press * or #, the RF transmission is effected and the S/N is
memorized into the receiver.
In this way I’ve 30 seconds to memorize the keypad into the receiver.
This is just a choice, because I can use even the standard way to have a RF transmission, simply
dialing the user code XXXXX and the button * or #.
master pwd, master pwd, *, 2, (beep), xxxxx [The user code must be present in the memory]
At this point, the led 5 starts to blink slowly.
Then, press * or # and the RF transmission is effected.
If no buttons are pressed within 30 sec. the procedure finishes.
4.3 HIDDEN FUNCTIONS
These 2 functions allow recovering the factory settings, if the master password is lost.
It is possible to reset the master password to the factory value [12345] leaving unchanged the user
memory but even reset the keypad at the factory defaults, erasing completely the user memory.
Master password reset ( reset the master password to 12345 and doesn’t affect the memory )
* + 1 simultaneously for 30 sec. , beep-beep, XXXXX (valid) beep-beep-beep
If the valid code is dialled within 20 sec. the procedure ends successfully otherwise nothing
changes
Total reset to factory default ( cancel all users codes + reset master password to 12345
# + 3 simultaneously for 30 sec , beep-beep-beep-beep
4.4) Regular RF Transmission
XXXXX, * or #, (Beep)
Code valid : Led N°5 blinks
Code not valid : Biiiiiiip
The device is approved by the FCC and it complies with Part 15 of the FCC Rules.
Its
operation is subject to the following 2 conditions:
1. This device may not cause harmful interference.
2. The device must accept any interference that may cause undesired operation.