DOLKWP318LIPSQ 318 MHz Keypad
Programming the Keypad The keypad will shut down for approx. 40 seconds if your entry code is not correct within a string of 18 digits. This will discourage an unauthorized person from trying use random numbers to access your property. STEP 1: Return to Default Setting 1. 2. 3. 4. 5. 6. Disconnect the power by remove the battery. Press 3 6 9 keys simultaneously. Power up the keypad again. Release 3 6 9 keys. Return to default Master Code 1 2 3 4 Clean all User Entry Code.
Preset Factory Codes User Enter Code 2 3 4 5 (Note: To reset the access code remove 9 volt battery form unit, Depress any key on the keypad and wait 10 seconds before installing battery. Send a signal to channel 1 of TX module: 2 3 4 5 (access code) Send a signal to channel 2 of TX module: # 2 3 4 5 - 2 (access code) Send a signal to channel 3 of TX module: # 2 3 4 5 - 3 (access code) Send a signal to channel 3 of TX module: # 2 3 4 5 - 4 (access code) Delete the Programmed User Entry Code 1. 2. 3. 4. 5.
