User's Manual

Default Master Code: 1
2 3 4
Add Access
1
2 3 4, 1#, Access Code: __ __ __ __ , Channel:1 #
Example:
STEP 1: Press 1
2 3 4
STEP 2: Press 1
#
STEP 3: Enter access code __ __ __ __
STEP 4: Press 1
# (multiple beeps confirm)
STEP 5: Press *
*
STEP 6: Test new access code. __ __ __ __ (Green light will flash 6 times
confirming that the new access code has been accepted.)
STEP 8: Proceed to program the keypad to the receiver.
STEP 7: Install 433 MHz wireless module (see next page)
Codes
Use Channel 1 if unsure. The different channels are dependent on the RF
terminal used. Any channel can be assigned for devices that connect to normally
open/normally closed.
1 2 3 4, 2#, Access Code: __ __ __ __ , #
Remove Access
Codes
Enter the Access Code you would like to delete.
1 2 3 4, 3#, Guest Code: __ __ __ __ , Channel:1
Add Guest Code
The Guest Code is a one-time use access code. Once used, the number will be
cleared from memory.
1 2 3 4, 4#, Toggle Code: __ __ __ __ , Channel:1
Add Access
Toggle Code
Entering Access Toggle Code will toggle the keypad to continuously activate.
Entering the code again will toggle the keypad off. Dip switch #6 on the circuit
board needs to be in the off position in order for this mode to work.
TOGGLE MODE ONLY FOR USE WHEN KEYPAD IS HARD WIRED.
1 2 3 4, 5#, Seconds:0-60, #
Set Relay
Output Time
Set the number of seconds the device will grant access before locking again.
1 2 3 4, 7#, Master Code: __ __ __ __ , #
Change Master
Code
Changes Master Code. If the Master Code is forgotten, this manual contains
instructions on how to reset the Master Code.
1 2 3 4, 8#
Clear All Codes
This will clear all data except the Master Code.
PROGRAMMING THE DOL1000-MF2 with 433 MHz Module