User's Manual

INTRODUCTION
The DOL1000-MF2 is a versatile keypad that has the option of running wirelessly. The DOL1000- MF2
can work with 6 volts of battery power or 6-24 volts of AC/DC. This keypad can be wired with
multiple wireless transmitters. DOL1000-MF2 can store up to 1000 access codes. Guest access
codes are also programmable, which are single-use codes for access. After 5 successive incorrect
codes, the keypad will lock for 4 minutes
CONNECTION TERMINALS
• V+/V-: These terminals will supply power to the transmitter.
• ANT: Antenna
• RF1-4: The DOL1000-MF2 can control up to 4 different channels. Each RF terminal represents
a different channel.
• GO: Connects to the green LED
• NOGO: Connects to the red LED
• KEYPADUTE: Connects to the DOL1000-MF2 lights located in front of the keypad
• NO (Normally open): Use N.O. for equipment that requires a temporary
surge of electricity to
activate. Example, Electric door locks, automated gates, push plates, etc.
• COM: Common ground
• NC (Normally closed): Use N.C. for equipment that requires a constant flow of electricity to
function properly. Example, Magnetic locks, receivers, etc.
• BATTERY 6VDC: If deciding to power the DOL1000-MF2 with a battery, then connect the
battery to these terminals.
• 6-24VAC/DC: If deciding to hardwir
e the DOL1000-MF2 directly to a power source, use these
terminals.
• Master Reset Button: Holding this button down for 5 seconds after reconnecting the keypad
to its power source will make the keypad beep 3 times. This will indicate that the Master Code
has been reset to 1234.
RESETTING THE KEYPAD AND MASTER CODE
Located on the DOL1000-MF2’s circuit board, the red Master Reset Button is used to reset the master
code
back to 1234. The following steps will reset the master code:
1. Remove the battery or eliminate the power source to the DOL1000-MF2 and wait for 30
seconds for the keypad to completely power off.
2. Press and hold the red Master Reset Button.
3. While holding the red Master Reset Button, reconnect the battery or power source to the
DOL1000-MF2.
4. Continue to hold the red Master Reset Button until the keypad beeps
3 times. This will
indicate that the Master Code has been reset to 1234.