Technical Specs

3 - NUMBERING
6 - BATTERY ACCESS
4 - PROGRAMMING
Each transmitter is manufactured and sold with a different factory set sequence
number and facility code.
The transmitter facility code and sequence number must be programmed into your
system memory. Your own installer or reseller will provide you the necessary
instructions for your system.
5 - OPERATION
a. Firmly depress either button until the small Green LED illuminates.
b. After the LED has illuminated, release the button. If the device you are attempting
to activate does not respond, repeat steps a. and b. or consult section 6
(Troubleshooting) of this manual.
To access the battery unscrew the fixing screw with a Phillips head screw-driver
(fig.2). Slide out the battery door. Insert the 12V - A23 alkaline battery, respecting
the polarity as indicated by the signs engraved on the battery site.
IS-T8L318TSUK Rev. 1 del 4.11.2022
The warranty period of 318 transmitters is 24
months, beginning from the manufacturing date of the transmitter.
During this period, if the product does operate correctly, due to a
defective component, the product will be repaired or replaced at the
sole discretion of Transmitter Solutions. The warranty does not extend to
the transmitter case which can be damaged by conditions outside the
control of Transmitter Solutions or to battery life.
Transmitter Solutions
WARRANTY
TRANSMITTER SOLUTIONS
2505 Chandler Avenue, Suite, 1
Las Vegas, NV 89120 -
[phone] - [phone] Fax
[e-mail]
2 - RANGE S8
S8318LIPW1KC : 1 button Transmitter S8
S8318LIPW2KC : 2 buttons Transmitter S8
S8318LIPW4KC : 4 buttons Transmitter S8
Battery door
Phillips head screw
Transmitter Solutions - Type : S8 318LIPW4KC
FCC ID : SU7318TRS8
This device complies with FCC Rules
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept interference received, including
interference that may cause undesired operation.
Part. 15 of the
Notice
Any changes or modification to equipment not expressly
approved by could void the manufacturer’s warranty.
Transmitter Solutions
Transmitter Solutions
The system does not receive the
transmitter signal.
The transmitter LED is ON
Check to verify the transmitter is
programmed into your system
PROBLEM
SOLUTION
The operating range is reduced
Replace the transmitter batteries
8 - TROUBLESHOOTING
7 - BATTERY STATUS
Led GREEN Normal level ~6000 pulses [*] - Normal range
Led ORANGE Attention level Max 300 pulses - Low range[*]
Led RED Low level Replace battery - No range
Led color
Battery level
TX Status
[ * ] : Depends on batteries type and operating conditions . Batteries life calculated
with 1-sec pulses.